Skip to main content

Laundry room layout

Side by side, a washer and dryer take about 56 inches of wall and 28–30 inches of depth; leave roughly 36 inches in front to stand and 42–48 to kneel at an open front-loader. Stacking saves width but not depth.

6 min readUpdated 2026-11-02

A laundry room needs three things: the machines, the floor in front of them, and somewhere to sort and fold. Full-size front-loaders are about 27 inches wide and 28–32 inches deep, so a side-by-side pair takes about 56 inches of wall; a stacked pair takes 27 inches of wall and stands about 6 feet tall.

The floor in front is where small laundries fail. A front-loader's door swings out about as far as the machine is wide, so plan roughly 36 inches of clear floor to stand and 42–48 inches to kneel at an open door with a basket (common planning guidelines; your machine's installation instructions have the exact door and venting clearances). Below are a 7 × 8 laundry room and a narrow galley laundry, both measured.

In this guide

  1. 1

    Side by side with a utility sink

    In a 7 × 8 foot room (7' × 7' 6" inside), a Front-Load Washer and Front-Load Dryer sit side by side on the back wall with a Utility Sink beside them. In front of the machines there's 4' 10" of floor to the opposite wall: room to open both doors, kneel and set down a basket. A Laundry Hanging Rail on the side wall takes hang-dry items out of the walkway, and the door swings clear. Flow check is OK. With a counter over the machines (front-loaders only), the same wall becomes a folding surface.

    Side by side: 4' 10" of floor in front of the machines.
  2. 2

    Stacked, in a narrow galley

    A 6-foot-wide galley (6' × 11' 6" inside) puts a Stackable Washer + Dryer, a Top-Load Washer and a 36" base cabinet on one wall and a hanging rail on the other. Between the machine fronts and the opposite wall there's 3' 8" (44"): enough to stand and load, a little tight to kneel at a front-loader with a basket. Stacking saves width, not depth: a stacked pair still needs the same 28–32" of depth plus room behind for the vent and hoses. Put the stack where you can reach the dryer controls (often at about eye level).

    Galley laundry: 3' 8" between the machines and the far wall.
  3. 3

    Code points that shape the room

    - Ceiling height: laundry rooms may have a ceiling as low as 6' 8" (IRC R305.1), lower than the 7 feet for habitable rooms. Check a stacked pair fits with room above for the vent. - Dryer duct length: the exhaust duct may be at most 35 feet from the dryer's transition duct to the outside terminal, reduced for each bend (IRC M1502.4.6.1 and its table). Put the dryer on or near an outside wall. - Behind the machines: installation instructions usually ask for several inches behind for the vent elbow and hoses, and closet installs need vent openings in the door. Your model's manual has the numbers.

    The side-by-side laundry in 3D.
  4. 4

    Plan it in RoomSketch3D

    1. Draw the room or a closet; add the door and any window. 2. Search washer or dryer: Front-Load Washer and Dryer, a side-by-side pair, Top-Load Washer, Compact Washer and Dryer, Stackable and Compact Stackable sets, an All-in-One Washer/Dryer, a Laundry Pedestal, a Wall-Mounted Dryer and Laundry Hanging Rails. A Utility Sink is under the entryway pieces. 3. Keep a tape measurement from the machine fronts to the opposite wall. 4. Try the Laundry Nook design idea for a ready-made compact layout. Smart Flow Check flags pieces that overlap each other or a wall, anything in a door's swing, anything inside the 36-inch approach zone in front of a door or opening, tall pieces in front of a window, recliners that can't recline, and a coffee table too close to the sofa. It does not measure aisles, work-triangle legs or code clearances, so check those with the tape measure.

    The galley laundry in 3D: stack, top-loader and a cabinet, rail opposite.

Tips

Top-loaders need headroom

A top-load lid opens upward, so no counter or shelf directly over it; keep shelves above the lid's open height.

Fold where you unload

A counter over front-loaders, or beside the dryer, saves carrying wet or warm loads across the room.

Mind the door

A laundry door that swings in over the machines blocks them. Flow Check flags pieces in the swing; a pocket or bifold door often fixes it.

Common confusions

A closet with no room to open the doors

A laundry closet off a 36" hall leaves 36" in front, enough to load but tight to kneel. Measure the open door against the hallway width.

Dryer far from an outside wall

Long duct runs with several bends can exceed the code length. Plan the dryer on or near an exterior wall.

Frequently asked questions

How much space do you need in front of a washer and dryer?

About 36 inches to stand and load, and 42–48 inches to kneel at an open front-loader door with a basket. These are common planning guidelines; check your model's door swing.

What's the minimum laundry room size?

A side-by-side pair needs about 5 feet of wall and roughly 5 feet of depth (machines plus floor in front). A stacked pair fits a 3 × 3 foot closet off a hallway.

How long can a dryer vent be?

Up to 35 feet under the IRC (M1502.4.6.1), reduced for each elbow; some dryer manufacturers allow a different length. Check your model.

Is there a laundry design idea to start from?

Yes — the Laundry Nook design idea drops in a compact, worked layout you can adapt. Browse the Design Ideas hub.

Sources

Start designing your room

Put this into practice in the room planner: draw it, furnish it, walk through it in 3D — on web, iOS, and Android.

Open RoomSketch3D

One-time purchase · No subscription · Web, iOS & Android